Syslog Enabled

This field allows you to enable and disable the protocol.

Log Host

This field allows you to designate hosts to receive and log Syslog messages. To designate a host as a log host, enter its IP Address in the Log Host field.

• With Phaser 840, 740 and 780 printers, you can enter IP host names or IP addresses, up to a maximum of 255 characters.
• With Phaser 360 printers, you can specify multiple addresses by separating them with a single space. The value entered must be a valid IP Address, and not 0.0.0.0, 255.255.255.255, or any address ending with the triplet 255. The maximum number of characters is 163.
• With Phaser 380, 560, 600 printers, you can specify multiple addresses by separating them with a single space. The value entered must be a valid IP Address, and not 0.0.0.0, 255.255.255.255, or any address ending with the triplet 255. The maximum number of characters is 155.

Log Priority

This field allows you to set a threshold indicating which priority level of message from the printer will be sent to the log host(s). Enter a number between 0 and 7.

The threshold numbers and their meanings are shown in the following list. The priorities listed in the table conform to BSD and SunOS conventions.

0 - emergency; printer is no longer available
1 - alert; printer needs immediate attention
2 - critical; critical error messages
3 - error; error messages
4 - warning; warning messages
5 - notice (printer's default); normal but significant messages
6 - informational messages
7 - debugging messages