|
Setting your IP address using the printer's front panel
|
|
You can use the printer's front panel to set its IP address.
- Note
- If you are attempting to perform any front panel procedures and you don't see the expected menu choices on the front panel display, the front panel may be locked. You may need to unlock the front panel before continuing. Contact your System Administrator for more information on unlocking the printer's front panel.
Press the Menu button; the front panel briefly displays Entering Menu, then displays Help Pages.
- Note
-
When you are in the menu, if the front panel is not used for 5 minutes, the printer returns to the Ready state.
-
Enter the Network Settings menu by pressing the right (----> ) or left (<----) arrow buttons until the front panel displays Network Settings.
-
Press the Menu button until the front panel displays Enable Interface.
-
Press the right (---->) arrow button; the front panel displays IP Address.
-
Press the Menu button; the front panel displays the following message:
000.000.000.000
Increment Shift Select
- Note
-
The IP address displayed on your printer may be different than the one in this example. Setting the IP address to 000.000.000.000 causes the printer to use Dynamic Address Resolution to set its IP address.
-
Press the Increment button to set the left-most digit of the address.
-
Press the Shift button to advance to the next digit. Press the Increment button to set this digit.
-
Use the Shift and Increment buttons as described in Step 7 to set the remaining digits.
-
When the address is correctly set, press the Select button to enter your settings into the printer; the front panel displays the following message:
Confirm Selection
Confirm
-
Press the Confirm button to confirm your selection.
- If the selection is a valid number, the front panel briefly displays Selected, then returns to the address display. Press the Exit button to return to the display of the parameter name, then press the right (---->) arrow button to display the name of the next addressing parameter.
- If the selection is not a valid number, the front panel briefly displays Error, then returns to the address display. Repeat Steps 6 through 9 to set the address correctly.
- Note
-
If you do not want to confirm your selection, press the Exit button to return to the address display and try again.
- Repeat Steps 5 through 10 to set the other addressing parameters: Network Mask, Gateway Address, and Broadcast Address.
-
When you are finished setting all the addressing parameters, return the printer to normal operation by pressing the Exit button until the front panel displays Ready.
Printer Types | Topics
|
| |
|
